2006 Subaru Impreza Airbag System Workshop Service manuals

2006 Subaru Impreza Airbag System Workshop Service manuals. Do not drop airbag modulator parts subject to high temperature of 93 ° C (203 ° F), or let water, oil or grease on them; Otherwise, the inner parts may be damaged and reliability lowered sharply. Do not allow water or oil that come into contact with the connector terminals. Don't touch the connector terminals. If any damage, opening or rust found at airbag system wire wires, do not attempt to repair by using soldering equipment. Make sure to replace the defective pipes with a new genuine part.When servicing a vehicle, you must turn off the ignition switch to OFF, Remove the cable from the battery and wait more than 20 seconds before you start work. • Airbag system is equipped with a backup power source. If the airbag system is repaired within 20 seconds after ground cable is detached, it can bloat. • If the airbag warning light lights up and repair the vehicle immediately. Airbag, pretensioner inflate wrong or not bloat in the collision. • If sensors, airbag module, the airbag control module, pretensioner and wires are deformed or damaged n replace them with new genuine parts.When you check in, using a test harness (1). Directly apply not the tester probe to any connector terminal in airbag. Damage to the terminal connector may cause an airbag to activate erroneously. When painting or perform sheet metal work on the side of the vehicle, including side sill, center pillar, and at the front and rear doors, remove the side airbag sensors and wire wires airbag system.

Download: 2006 Subaru Impreza Abag System Workshop Service manuals