Suzuki DRZE Installation Manual

: This step requires bleeding the rear brake. If you do not feel comfortable performing this step please refer it to a qualified mechanic. Installation: Remove the guard that protects the rear master cylinder and reservoir. Temporarily remove the bolt that secures the brake reservoir to the frame. Remove the bolt that holds the banjo fitting to the top of the rear master cylinder.

Replace this bolt with the provided hydraulic switch retaining the upper and lower crush washers as shown in Photo 4. Bleeding the Brakes: Do not begin this process without a fresh bottle of brake fluid. Remove the lid from the brake fluid reservoir. Put the box end of 8mm wrench over the brake bleed nipple and install the bleed hose (supplied) tightly over the nipple. Position the loop on the hose above the nipple as shown in Photo 5 with the other end of the hose in a container to catch the fluid.

Crack the bleed nipple open about 1/8 to a quarter turn keeping the loop in the hose vertical. Slowly depress the brake pedal to fill the hose with fluid. Pump slowly until you have brake fluid extending up into the loop, then you can pump the pedal fairly aggressively to drive air out of the system – The fluid above the bleed nipple will prevent air from re-entering the system.

get here Suzuki DRZE Installation Manual