2000-2005 TOYOTA TUNDRA 2WD and 4WD COIL OVER SYSTEM. Take a show stock strut assembly site and then use external coil spring compressor to compress the spring enough to remove the top nut. WARNING: THE COIL SPRING IS UNDER EXTREME LOAD. .Remove the top nut and remove stock devices mount, Discard stock coil spring and shock.CHECK ALL PARTS INCLUDED IN THIS KIT TO THE PARTS LIST ABOVE BEFORE BEGINNING INSTALLATION OF THE KIT. IF ANY PIECES are MISSING, CONTACT FABTECH at 909-597-7800. VEHICLES that will receive the ABOVE SIZE TYRES SHOULD INSPECT BALL JOINTS, TIE RODS ENDS and IDLER ARM EVERY 2500-5000 MILES FOR WEAR and REPLACE AS necessary. READ ALL INSTRUCTIONS THOROUGHLY FROM START TO FINISH BEFORE BEGINNING INSTALLATION! WARNING: FABTECH RECOMMENDS THAT YOU EXERCISE EXTREME CAUTION WHEN WORKING WITH COIL SPRINGS TO AVOID THE POSSIBILITY OF SERIOUS INJURY. Disconnect the negative terminal on the battery. With the truck, who sits on a flat and level surface, measuring distance from the Centre of the front spindle to the top of fender opening. Write this measurement down, you should refer back to it later.Remove the three nuts securing the upper spring seat to frame mount. Remove the nut and bolt securing the bottom of the spring seat/strut Assembly for lower control arm and remove the Assembly from the truck.
Download: 2000-2005 TOYOTA TUNDRA 2WD and 4WD COIL SYSTEM
