TOYOTA HILUX 3 L 2.8 LTR FITTING MANUAL. Remove the complete exhaust system and exhaust manifold.
2. remove the oil pressure plug from the rear of the oil Gallery and fit nipple drinker, T piece and flare nipple drinker then solved Customize oil supply line. If the oil pressure sender unit is mounted on the back of the block and then move to the end of the t piece block otherwise t piece with plug..
3. remove the oil drain on block to the vacuum pump. Now fits banjo Assembly with enhanced hose banjo bolt and connected to the banjo and fit oil brain drain hoses for turbo with elbow to bottom vacuum pump oil return. 4. Fit two full stainless heatshield to the firewall by using the two existing protruding screws and two nuts supplied. 5. Fit exhaust manifold with single turbo to the engine by means of new gasket, if required. Now connect the turbo oil feed line and oil return line. When you have oil feed and return line located so they don't rub on anything, tighten both ends using a spanner and hose clamps, respectively. Note: oil feed line should be facing around the back of the engine, and then to the rocker cover for turbo – Keep away from heat source. 6. Remove the engine breathing space from the intake manifold and rocker cover, now block the outlet on the intake manifold with rubber cap plug and clamp. Associate the new breather hose loosely to the rocker cover ready for attachment to the new position. 7. Customize new airbox forrest down bracket with original 6 mm screws and connecting to the intake manifold with turbo hose and clamps supplied. Connect now air cleaner and turbo air box uses cast rørknæ, turbo hose and clamps to. You can now connect the engine breathing space to elbow below the air box, make sure that the breather pipe not kink as this will cause the turbo passing oil. Connect 4 ways casting with convoluted tubing air cleaner and 2 x 45 ° bends with steel spacers and hose clamps are supplied.
Download: TOYOTA HILUX 3 L 2.8 LTR fitting MANUAL